File Functions
Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
10-6
These are found on the Disk Options screen (Figure 10.2).
Figure 10.2 The Disk Options Screen (USB Storage Device Selected)
Source
In order to successfully locate the desire
d tests, you must designate the source of the tests—the
location on which they currently are stored. The primary choices are HARD DRIVE, FLOPPY, and up
to two USB storage devices. When transferring tests, CLASSIC SERIAL will also appear on the Source
list.
With HFA-NET Pro enabled, FILE SERVER also becomes also becomes an option.
When viewing tests, if you purchased and register
e
d DICOM Gateway 2.0, DICOM ARCHIVE can
also be selected.
Destination
The Disk Options screen includes a destination choice. Destinations include FLOPPY
, HARD DRIVE,
CLASSIC SERIAL, and up to two USB storage devices. If HFA-NET Pro is enabled, DATA EXPORT HOST
and EMR/PMS HOST are also destinations.
When transferring tests, if you purchased and re
gistered DICOM Gateway 2.0, DICOM ARCHIVE will
also be available.
FILE SERVER also becomes also becomes an option with HFA-NET Pro.
Note: Both the Source and the Destination can be set to FL
OPPY at the same time. This occurs when
you want to copy data from one floppy disk to another. The HFA II-
i
will alert you as to when to
insert the Source disk and when to insert the Destination disk into the floppy disk drive. Be careful
not to mix up the Source and Destination floppy disks. Data can be lost!
Note: Both the Source and the Destination cannot be set to a USB storage device at the same time.
To Next Page
Loading...
Need help?
General
