Caster lock
Table height switch
Printrex printer
(optional)
Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
Introduction & Instrument Setup
1-25
Figure 1.7 Power Table for the HFA II-i
Additional Components
Many external devices are available to help operate your HFA II-
i
. The following is a description of
these devices and how to attach them to the HFA II-
i
properly.
Printers
External printers are available for the HFA II-
i
. Many HFA II-
i
instruments print to the standard
Printrex printer. Some offices prefer a stand-alone printer for the laser-quality and the standard size
paper printout. You can designate the printer type to be used with your instrument. The choices are
Printrex, HP
®
LaserJet
®
, HP DeskJet
®
, and Shared (see “Printer,” on page 2-11). There are two
ways to print from the HFA—through the parallel port or a shar
ed printer on a network. Selecting
Shared selects a shared printer on a network. The other printer type selections all use the parallel
port on the HFA. Basic instructions for connecting a printer to the HFA II-
i
are given below.
Note: The list of parallel port supported printers changes
over time, as older printers are
discontinued by their manufacturers and newer models take their place. Contact your local Zeiss
customer care representative for a list of currently available HFA II-
i
parallel port supported printers.
For a shared printer, most PCL
®
-3 and PCL-5 printers will work.
To Next Page
Loading...
Need help?
General
