Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
Networking Reference
I-1
(I) Networking Reference
How to Use This Chapter I-1
Connecting Your Network Components I-3
Setting Up Your HFA Network I-4
File Server Access Protocol for FTP or Shared Folder I-8
Archiving Data I-14
Setting Up Save & Transmit to a Network File Server I-21
Setting Up Exporting to Non-DICOM EMR/PMS Systems and
DICOM Systems using DICOM Gateway 1.0
I-22
Setting Up Work Lists for Non-DICOM EMR/PMS Systems and
DICOM Systems using DICOM Gateway 1.0
I-23
Setting Up Save & Transmit for EMR/PMS/DICOM Systems I-24
Setting Up Printing To a File I-25
Backing Up and Restoring Your HFA Network Configuration I-27
Network Diagnostics I-28
Network Troubleshooting Error Messages I-31
Networking Terminology I-38
Serial Communications Protocols Used by HFAs I-40
Note: It is strongly recommended that you use the
EasyConnect
RCT in Easy Mode instead of
manually configuring your network settings on your HFA II-
i
instruments (see “EasyConnect RCT
1.0,” on page G-1).
Licensing HFA-NET Pro and DICOM Gateway 2.0
The networking features described in this chapter are only available as licensed software. See
Appendix (J), "Installing & Licensing HFA II-i Software," for more information.
Note: The networking features discussed oper
ate with the Version 4.0 system software and higher.
How to Use This Chapter
This chapter is here to help the Network or IT Administrator setup your HFA II-
i
in a Peer-to-Peer or
Networked environment. The following sections hold all the information you need. By the end of
this chapter you will be familiar with:
• how to connect your HFA II-
i
to your office network
• how to configure your HFA II-
i
for networking
• how to organize patient records on the file server using Patient Folders
• how to transfer data to and from an EMR/PMS/DICOM system
To Next Page
Loading...
Need help?
General
