Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
Kinetic Testing
13-25
2Start the test and allow the test to proceed through the 8
preprogrammed meridians.
3In the Step by Step mode, you will be see this screen upon the
completion of the 8 meridians. Press END TEST for storing test data.
Prior to ending the test, you can activate SPECIAL MAPPING to allow
sear
ching for isolated scotomas. This extra testing will not change the
calculated Efficiency Score. The next part of this section goes into
greater detail about Special Mapping.
4This screen will appear after pressing END TEST in the Step by Step
mode. This is also the screen that will appear at the end of an
Automatic test. All of these options are covered later in this section.
To Next Page
Loading...
Need help?
General
