Reference Manual ADuCM356
PROGRAMMABLE SWITCHES CONNECTING THE EXTERNAL SENSOR TO THE HIGH-SPEED DAC
AND HIGH-SPEED TIA
analog.com Rev. A | 115 of 312
â–º The Dx switches are controlled via the DSWFULLCON register
bits.
â–º The Px switches are controlled via the PSWFULLCON register
bits.
â–º The Nx switches are controlled via the NSWFULLCON register
bits.
â–º The transmit switches (including T9, T10, and T11) are controlled
via the TSWFULLCON register bits.
Perform the following steps if SWCON, Bit 16 = 1 and if the
xSWFULLCON registers are used:
1. Clear SWCON, Bit 16 = 0.
2. Write to DSWFULLCON, TSWFULLCON, NSWFULLCON, and
PSWFULLCON.
3. Set SWCON, Bit 16 = 1. This final write ensures all switches
update simultaneously.
The status of all switches can be read from the switch status
registers at any time. These registers indicate whether each switch
is open or closed. The full switch status registers are available in
the Register Details: Programmable Switches section.
To Next Page
Loading...
Need help?
General