EasyManua.ls Logo

Ducati DARK 749 - Page 607

Ducati DARK 749
628 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A
B
C
D
E
F
G
H
L
M
N
P
Impianto elettrico
Electric system
sezione / section
P 8
59 749/749 DARK/749S Aggiornamento/Update - M.Y. 2006 - edizione/edition 00
Segnalazioni delle spie e delle
indicazioni
Ogni volta che si ruota la chiave nel
blocchetto avviamento da ON a OFF,
il sistema immobilizer attiva il blocco
motore.
All'avviamento del motore, ruotando
la chiave da OFF ad ON, il sistema
emette le seguenti segnalazioni:
- se il codice viene normalmente
riconosciuto l'indicazione CODE sul
display multifunzione del quadro
strumenti, si accende e poi si spegne.
Così accade anche per la spia EOBD
(5) (segnalazione anomalia controllo
motore accensione - iniezione)
- se il codice non è stato riconosciuto
l'indicazione CODE e la spia EOBD
rimangono accese. Non parte il
motore. Ripetere la procedura di
accensione ed eventualmente
provare con l'altra chiave nera.
Importante
Durante la procedura di
programmazione di seguito indicata,
quando si inserisce una chiave nel
blocchetto avviamento è importante
tenere le altre lontano dal blocchetto
stesso, onde evitare che interferiscano.
Note
E’ possibile programmare il
sistema immobilizer solamente nel
caso in cui venga effettuata la
programmazione delle chiavi
utilizzando almeno due chiavi NERE,
oltre alla chiave ROSSA per un max di
8 chiavi (compresa la chiave ROSSA).
Warning lights and indicators
Whenever the ignition key is turned
from ON to OFF, the immobilizer
system activates the engine start
protection system.
When the engine is started and the key
is turned from OFF to ON, the system
generates the following signals:
- if the code is recognised, the CODE
indication on the multifunction
display will light up and then switch
off. This also happens with the
EOBD led (5) (ignition/injection
system control error warning light)
- if the code is not recognised, the
EOBD led and CODE symbol will
light up and stay on. The engine
will not start. Repeat the starting
procedure and try using the other
black key.
Important
During the programming
procedure described below, when a
key is inserted in the ignition switch,
always keep the other keys well
away from the switch to avoid the
risk of interference.
Notes
The immobilizer system can
be programmed only if the keys are
programmed using at least two
BLACK keys in addition to the RED
key, with a maximum of 8 keys in
all (including the RED key).
5

Table of Contents

Related product manuals