1-72
Overview
Troubleshooting
Table 1-10. AutoSynch™ Error Messages
If the router is reporting that the compact flash card is removed, check the
back panel to be sure that the compact flash card is firmly mounted in the slot.
Even if you have identical copies of SROS.BIZ on both flash and compact flash,
the router will not be able to report that SROS.BIZ is synched until there are
synchronized copies of startup-config on compact flash and flash. Both loca-
tions must have files with exactly the same filename.
Because the router always synchronizes files from compact flash to internal
flash memory, it will report error messages if you do not have a copy of the
SROS.BIZ or startup-config files on compact flash.
Copy the missing file from flash to cflash by entering the following commands
from the enable mode context:
ProCurve# copy flash SROS.BIZ cflash SROS.BIZ
ProCurve# write memory
Then enter autosynch from the enable mode context to synchronize the files.
Note During the AutoSynch synchronization process, do not remove the compact
flash card. Wait for state completion.
If the router is reporting that the files are not synchronized after you have
ensured that there are copies of SROS.BIZ and startup-config on the compact
flash card, check the filenames.
Note Filenames are case sensitive. SROS.biz is not the same file as SROS.BIZ. It is
important that the filenames on the compact flash card are exactly correct.
Error Message Action
compact flash removed Make sure the compact flash card is firmly mounted in the
compact flash slot
CFLASH startup-config
does not exist
From the enable mode context, enter write memory.
CFLASH SROS.BIZ does
not exist
From the enable mode context, enter copy fl SROS.BIZ cfl
SROS.BIZ.
CFLASH startup-config
not synched
Enter autosynch from the enable mode context.
To Next Page
Loading...
Need help?
General
