HP ProCurve 7000dl Series

7-57
ADSL WAN Connections
Quick Start
Table 7-9. Training Modes Supported by the ProCurve Secure Router
Configure the Data Link Layer: the ATM Interface and
Subinterface
Before you configure the Data Link Layer for the ADSL connection, you must
know the settings that you should enter for the following:
■ Data Link Layer protocol
• Asynchronous Transfer Mode (ATM) only
• point-to-point protocol (PPP) over Ethernet (PPPoE)
• PPP over ATM (PPPoA)
• routed bridged encapsulation (RBE)
■ virtual path identifier/virtual channel identifier (VPI/VCI)
■ ATM encapsulation
■ IP address
• static IP address
• unnumbered interface
• IP address negotiated with the service provider’s router
Your service provider should tell you which settings to enter.
Configure ATM Only
1. From the global configuration mode context, create the ATM interface.
Syntax: interface <interface> <number>
Command Option ADSL2+ Annex A ADSL2+ Annex B
training-mode ADSL2 Yes Yes
training-mode ADSL2+ Yes Yes
training-mode G.DMT Yes Yes
training-mode G.LITE Yes No
training-mode Multi-Mode Yes Yes
training-mode READSL2 Yes No
training-mode T1.413 Yes No