4-39
Configuring E1 and T1 Interfaces
Quick Start
Quick Start
This section provides the commands you must enter to quickly configure an
E1 or T1 interface on the ProCurve Secure Router. Only a minimal explanation
is provided.
If you need additional information about any of these options, see “Contents”
on page 4-1 to locate the section and page number that contains the explana-
tion you need.
Configuring an E1 or T1 Interface
Before you begin to configure an E1 or T1 interface, you should know the
settings that you must enter for the following:
■ number of channels used
■ line coding
■ frame format
■ clock source
Your public carrier should provide you with this information.
To configure the E1 or T1 interface, complete these steps:
1. If you are configuring an E1 interface, use unshielded twisted pair (UTP)
cabling with RJ-48C connectors to connect the E1 port on the ProCurve
Secure Router to the external CSU provided by your public carrier. If you
are configuring a T1 interface, use UTP cabling with RJ-48C connectors
to connect the T1 port to the wall jack provided by your public carrier.
2. Establish a terminal session with the ProCurve Secure Router. You are
automatically at the basic mode context.
ProCurve>
3. Move to the enable mode context. If you have configured a password for
the enable mode context, enter the password.
ProCurve> enable
Password:
4. Move to the global configuration mode context.
ProCurve# configure terminal
To Next Page
Loading...
Need help?
General
