2-70
Controlling Management Access to the ProCurve Secure Router
Quick Start
Note You can configure an access control list (ACL) to block Telnet access. For
instructions on configuring this ACL, see Chapter 5: Applying Access Control
to Router Interfaces in the Advanced Management and Configuration Guide.
Configuring Local User Lists
You can configure multiple usernames and passwords to be used for FTP,
HTTP, and SSH access to the router. From the global configuration mode
context, enter:
Syntax: username <username> password <password>
These passwords are stored in the local user lists.
To encrypt all the passwords configured on the ProCurve Secure Router, enter
the following command from the global configuration mode context:
ProCurve(config)# service password-encryption
The ProCurve Secure Router automatically supports SSH and FTP access.
After you configure a password in the local user list, you can access the router
through these methods.
Enabling HTTP Access. From the global configuration mode context,
enter:
ProCurve(config)# ip http server
If you want to use Secure Sockets Layer (SSL) to protect the communications
between your PC and the router, enter:
ProCurve(config)# ip http secure-server
Enabling the SCP Server. To encrypt files as they are copied to and from
the ProCurve Secure Router, enter the following command from the global
configuration mode context:
Syntax: ip scp server
To Next Page
Loading...
Need help?
General
