14-93
Using the Web Browser Interface for Basic Configuration Tasks
Configuring Demand Routing for a Primary or Backup Connection
You can use the options in the Maintenance window to troubleshoot a BRI
interface:
■ Occasionally, a BRI interface may enter a loop if it does not complete the
call disconnect process. Select the Reset option and click Apply to reset
the port hardware.
■ You can restart the D-channel by selecting the Restart-d option and
clicking Apply. For example, you might need to restart the D-channel if a
problem occurs during the call process.
Configuring an ISDN Group
If you are configuring demand routing for a primary ISDN module, you must
configure an ISDN group. If you are configuring demand routing for a backup
ISDN module, skip this step.
To configure an ISDN group, complete the following steps:
1. Click ISDN Group in the System section of the navigation bar.
Figure 14-67. ISDN-Group
2. To add a new ISDN group, click the Add New Group button.
To Next Page
Loading...
Need help?
General
