13-34
Dynamic Host Configuration Protocol (DHCP)
Quick Start
Quick Start
This section provides the commands you must enter to quickly configure:
■ the router to act as a DHCP server for a subnet
■ the router to assign a fixed DHCP address to a single host
■ a router interface to act as a DHCP client
Only a minimal explanation is provided. If you need additional information
about any of these options, check “Contents” on page 13-1 to locate the section
that contains the explanation you need.
Table 13-2. DHCP Server Settings
Configurations Parameters Your Setting
network’s static IP
addresses
first address in range
last address in range
other static address
parent pool for a range of
subnets (optional)
pool name
range of subnets and prefix
length for range
DHCP pool for a subnet pool name
subnet address and mask (or
prefix length)
default gateway
servers primary DNS server
secondary DNS server
primary WINS (NetBIOS)
server
secondary WINS (NetBIOS)
server
TFTP server
NTP server
To Next Page
Loading...
Need help?
General
