1-45
Overview
Software Overview
Some examples of clear commands include the following:
Syntax: clear ip policy-sessions
This command clears all sessions established using the ACPs applied to router
interfaces.
Syntax: clear ip route [** | <A.B.C.D>]
The ** option clears all routes learned through a routing protocol. Static
routes are not affected. You can clear a single route by entering the destination
IP address.
Clock
The clock command in the enable mode context allows you to set the clock,
adjust for the time zone, and manage the clock source. To view the options
for the clock command, enter:
Syntax: clock ?
For example, to set the clock and the time zone, enter:
Syntax: clock set <HH:MM:SS>
Syntax: clock timezone <zone>
Enter clock timezone ? for a complete list of keywords for the time zones of
various locations.
Daylight Saving Time Auto Correction. The router is set to automatically
correct the time for daylight saving time. If the router is operating in an area
that does not observe daylight saving time, you should disable this option
using the clock no-auto-correct-dst command. Enter:
ProCurve# clock no-auto-correct-dst
To re-enable daylight saving time correction, enter:
ProCurve# clock auto-correct-dst
To Next Page
Loading...
Need help?
General
