HP ProCurve 7000dl Series User Manual

6-42
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Configuring the Logical Interface
The HDLC settings are described in the sections that follow.
Activate the HDLC Interface
You must activate the HDLC interface. From the HDLC interface configuration
mode context, enter:
ProCurve(config-hdlc 1)# no shutdown
Although the HDLC interface is activated, its status will not change to up until
it is bound to a physical interface. It can then begin to negotiate an HDLC
session, and if that negotiation is successful, the status of the HDLC interface
will change to up.
Configure an IP Address for the WAN Connection
You configure the IP address for the WAN connection on the HDLC interface,
rather than on the physical interface. There are two ways to assign an IP
address to the HDLC interface:
■ assign a static IP address
■ configure the HDLC interface as an unnumbered interface
Assign a Static IP Address. To assign the HDLC interface an IP address,
enter the following command from the HDLC interface configuration mode
context:
Syntax: ip address <A.B.C.D> <subnet mask | /prefix length>
hdlc • no shutdown
• ip address <A.B.C.D> <subnet mask | /
prefix length>
or
• ip unnumbered <interface>
• activates the interface
• assigns a static IP address to the
HDLC interface
• configures the HDLC interface to
use the IP address assigned to
another interface
6-42
global
configuration or
interface
configuration
• bind <number> <physical interface>
<slot>/<port> [<tdm-group number>]
hdlc <interface number>
• binds the physical interface to the
logical interface
• requires the tdm-group number for
E1 and T1 interfaces, but not for
serial interfaces
6-44
Interface
Configuration
Mode Context
Command Explanation Page

HP ProCurve 7000dl Series Specifications

General

Brand	HP
Model	ProCurve 7000dl Series
Category	Network Router
Language	English