1-5
Overview
Using This Guide
Using This Guide
The ProCurve Secure Router Basic Management and Configuration Guide
describes how to use the ProCurve Secure Router 7000dl Series in a network
environment. Specifically, it focuses on two router models:
■ ProCurve Secure Router 7102dl
■ ProCurve Secure Router 7203dl
This guide describes how to use the command line interface (CLI) and the Web
browser interface to configure, manage, monitor, and troubleshoot basic
router operation. In particular, this guide focuses on configuring the router’s
physical interfaces and basic Data Link Layer protocols to establish LAN and
WAN connections.
This guide assumes that your router uses the J06_03 Secure Router operating
system (OS) or above.
If you need information on how to configure advanced router functions such
as virtual private networks (VPNs), multilink connections, backup connec-
tions, network address translation (NAT), quality of service (QoS), multicast-
ing, or routing protocols, see the ProCurve Secure Router Advanced
Management and Configuration Guide.
Understanding Command Syntax Statements
This guide uses the following conventions for command syntax and
information:
Syntax: show access-lists [<listname>]
Syntax: [permit | deny] [any | host <A.B.C.D> | <A.B.C.D> <wildcard bits>]
■ Angle brackets ( < > ) enclose a description of a command element, a part
of the command in which you enter information specific to your particular
router or WAN. For example, in the first command shown above, you
replace <listname> with the name of a particular access control list
(ACL) configured on your router.
■ Vertical bars ( | ) separate alternative, mutually exclusive elements.
To Next Page
Loading...
Need help?
General
