4-27
Configuring E1 and T1 Interfaces
Viewing Information about E1 and T1 Interfaces
To return a threshold to its default setting, enter this command from the global
configuration mode context:
Syntax: no thresholds [BES | CSS | DM | ES | LCV | LES | PCV | SEFS | SES | UAS] [15Min
| 24Hr]
For example, to return the 15-minute SES threshold to its default setting of
10, enter:
ProCurve(config)# no threshold SES 15Min
To return all thresholds to their default setting, enter:
ProCurve(config)# no thresholds
Viewing Information about E1 and T1
Interfaces
To view status or configuration information about a E1 or T1 interface, you
can use the show commands listed in Table 4-6.
Table 4-6. show Commands
Command Explanation
show interfaces displays information about all the interfaces—active or
inactive—on the ProCurve Secure Router
show in
terface <inte
rface>
<slot>/
<port> [
realtime |
performance-statistics]
displays information about a specific physical interface
show running-config displays all of the settings that you have configured for the
ProCurve Secure Router
show running-config verbose displays the entire running-config, including the settings
that you have configured and the default settings that you
have not altered
show
runnin
g-config
interf
ace <i
nterface
> <slo
t>/<port
>
displays the settings that you have configured for a particular physical interface
show
runnin
g-config
interf
ace <i
nterface
> <slot>/<p
ort>
verbose
displays the entire running-config for a particular
interface, including the settings you configured and the
default settings that you have not altered
To Next Page
Loading...
Need help?
General
