14-48
Using the Web Browser Interface for Basic Configuration Tasks
Configuring Ethernet Interfaces
• Unnumbered—To set up the Ethernet interface with the same IP
address as another interface, click the Unnumbered option. The
Interface box is displayed.
Use the pull-down menu for the Interface box to select the appropri-
ate interface. The menu will display any ATM subinterfaces, Frame-
Relay subinterfaces, HDLC interfaces, loopback interfaces, and PPP
interfaces that are already configured.
Dynamic DNS
8. Configure dynamic DNS, if needed. For more information about dynamic
DNS, see “Configuring Dynamic DNS” on page 14-124.
a. For Dynamic DNS, use the pull-down menu to select DynDNS.org,
DynDNS.org Static, or DynDNS.org Custom. Choose the service for
which you registered with DynDNS.org. Additional boxes are dis-
played, allowing you to configure information about your account
with DynDNS.org.
b. For Dynamic DNS Hostname, enter the hostname you are registering
for the interface.
c. For Dynamic DNS Username, enter the username for your company’s
account with DynDNS.org.
d. For Dynamic DNS Password, enter the password for your company’s
account with DynDNS.org.
Secondary IP Settings
9. To set secondary IP addresses for your Ethernet interface, click Add a
new Secondary IP Address. Then enter the IP address and subnet mask
in the boxes provided.
10. Click Apply to save your configurations.
Ethernet Interface Statistics
You can view status information about the Ethernet interface at the bottom
of the Ethernet Configuration window. This display provides basic informa-
tion; for a more comprehensive readout, access the CLI and enter show
interface e
therne
t 0/<port
>
at the enable mode context.
To Next Page
Loading...
Need help?
General
