14-36
Using the Web Browser Interface for Basic Configuration Tasks
Configuring Passwords to Control Management Access to the Router
However, if a user enters the wrong username or the wrong password for a
particular username, the user failed to authenticate to the router; the access
method did not fail. In this case, the user will be denied access to the router.
You can use the Web browser interface to specify the RADIUS and TACACS+
servers that the ProCurve Secure Router can contact. You can also configure
authentication using RADIUS or TACACS+ from the Web browser interface.
However, you must configure authorization and accounting using TACACS+
from the CLI.
Configuring Authentication Using a RADIUS Server
If you want to use a RADIUS server to authenticate users who access the
router, you must enable the AAA subsystem.
1. Select Passwords in the navigation bar and scroll to the bottom of the
Add/Modify/Delete Users window.
2. In the Service Authentication section, select AAA Mode Enabled.
3. Click Apply to enable the AAA subsystem.
4. Configure the settings for a RADIUS server.
a. Select the Radius tab.
To Next Page
Loading...
Need help?
General
