14-101
Using the Web Browser Interface for Basic Configuration Tasks
Configuring Demand Routing for a Primary or Backup Connection
1. On the Assign Dial Interfaces to a Resource Pool screen, in the Member
field, use the pull-down menu to select either:
• an ISDN group, if you are configuring demand routing for a primary
ISDN interface
• an interface, if you are configuring demand routing for a backup
interface
2. In the Resource Pool field, use the pull-down menu to select the resource
pool. Make sure that you select the same resource pool that you assigned
to the demand interface.
3. If you assign a BRI interface to the resource pool, assign it a priority
number.
4. Click the Add button. You are returned to the first demand routing screen.
Configuring Connect Sequences
You must configure a connect sequence to specify the dial-up instructions for
the connection. When you configure a connect sequence through the Web
browser interface, you specify:
■ the number of the demand interface
■ the telephone number that the router dials to connect to the other site
■ the type of dial-up connection that the router should establish
■ the number of times that the router should try to process this connect
sequence (per connect-sequence attempt).
When the ProCurve Secure Router detects interesting traffic and no connec-
tions are currently established to carry this traffic, the router uses a connect
sequence to try to establish a connection. This process is called an activation
attempt.
You can configure more than one connect sequence for a demand interface.
To Next Page
Loading...
Need help?
General
