6-47
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Configuring the Logical Interface
Settings Explained in Other Chapters
In addition to configuring these settings for an HDLC interface, you can:
■ assign ACPs or ACLs to control access to the HDLC interface
■ enable bridging
■ assign crypto maps to enable VPNs
■ configure settings for routing protocols
■ configure QoS settings
Table 6-10 lists additional configurations that you can enter from the HDLC
interface and the page number where you find information about those
configurations.
Table 6-10. Additional Configurations for the HDLC Interface
Settings Configuration
Guide
Page
access controls to filter incoming and outgoing traffic Advanced 5-19, 5-38
bridging Basic 10-6
VPNs Advanced 10-46
routing commands for OSPF, RIP, or BGP Advanced 15-1
QoS settings Advanced 8-28
To Next Page
Loading...
Need help?
General
