14-72
Using the Web Browser Interface for Basic Configuration Tasks
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
•Static—Select this setting if you want to configure a static IP address.
Enter the appropriate address for the Frame Relay subinterface in the
boxed provided.
• DHCP—Select this setting to configure the subinterface as a Dynamic
Host Configuration Protocol (DHCP) client.
• Unnumbered—To set up the Frame Relay subinterface with the same
IP address as another interface, click the Unnumbered option. The
Interface box is displayed.
Use the pull-down menu for the Interface box to select the appropri-
ate interface. The menu will display any ATM subinterfaces, Frame-
Relay subinterfaces, HDLC interfaces, loopback interfaces, and PPP
interfaces that are already configured.
Configure Dynamic DNS
7. Configure dynamic DNS, if needed. For more information about dynamic
DNS, see “Configuring Dynamic DNS” on page 14-124.
a. For Dynamic DNS, use the pull-down menu to select DynDNS.org,
DynDNS.org Static, or DynDNS.org Custom. Additional boxes are
displayed, allowing you to configure information about your account
with DynDNS.org.
b. For Dynamic DNS Hostname, enter the hostname required to register
the interface’s IP address.
c. For Dynamic DNS Username, enter the username for your company’s
account with DynDNS.org.
d. For Dynamic DNS Password, enter the password for your company’s
account with DynDNS.org.
8. Click Apply to activate your settings.
9. Repeat steps 9 through 17 for each PVC you need to configure for the
Frame Relay interface.
Status Information
10. To view information about the Frame Relay subinterface, scroll to the
bottom of the Configuration for Frame Relay subinterface window.
To Next Page
Loading...
Need help?
General
