2-41
Controlling Management Access to the ProCurve Secure Router
Troubleshooting AAA
Figure 2-5. show radius statistics
debug radius Command
You can view debug messages about RADIUS servers in real time. From the
enable mode context, enter:
Syntax: debug radius
The RADIUS debug messages show the communication process with the
remote RADIUS servers, as shown below.
RADIUS AUTHENTICATION: Sending packet to 172.22.48.1 (1645).
RADIUS AUTHENTICATION: Received response from 172.22.48.1.
To end the debug messages, enter one of the following commands:
Syntax: no debug radius
Troubleshooting the TACACS+ Server
You can display information about the authentication, authorization, and
accounting packets that the ProCurve Secure Router exchanges with the
TACACS+ server. From the enable mode context, enter:
Syntax: show tacacs+ statistics
Figure 2-6 shows the type of information displayed with this command.
Auth. Acct.
Number of packets sent: 10 0
Number of invalid responses: 2 0
Number of timeouts: 0 0
Average delay: 2 ms 0 ms
Maximum delay: 3 ms 0 ms
To Next Page
Loading...
Need help?
General
