1-57
Overview
Software Overview
Figure 1-27. show t1 1/1 realtime Command
The show event command displays the event-history log. The event-history
is a log of the dates, times, and description of events such as connections going
up or down or attacks blocked by the Secure Router OS firewall.
Many show commands also have options that allow you to focus or specify
the display. For a list of available options for a specific show command, enter
the command at the CLI and press
?.
Undebug
This command disables a debug command. To turn off all currently active
debug commands, enter undebug all.
Write
This command is a file management command that manages the running-
config file.
■ write memory. This command is similar to the copy command. Entering
write memory will save the running-configuration to the startup-config-
uration. In J03_01.biz and later, the running-config will automatically save
--------------------------------------------------------------------
t1 1/1 is UP
Receiver has no alarms
T1 coding is B8ZS, framing is ESF
Clock source is through t1 1/2, FDL type is ANSI
Line build-out is 0dB
No remote loopbacks, No network loopbacks
Acceptance of remote loopback requests enabled
Tx Alarm Enable: rai
Last clearing of counters never
loss of frame : 1, last occurred 00:10:27
loss of signal : 1, last occurred 00:10:41
AIS alarm : 0 40
Remote alarm : 0
DS0 Status: 123456789012345678901234
NNNNNNNNNNNNNNNNNNNNNNNN
Status Legend: '-' = DS0 is unallocated
'N' = DS0 is dedicated (nailed)
Line Status: -- No Alarms --
(OUTPUT TRUNCATED)--------------------------------------------------
Exit - 'Ctrl-C', Freeze - 'f', Resume - 'r'
Instructions
for pausing
or ending
the output
To Next Page
Loading...
Need help?
General
