1-56
Overview
Software Overview
Figure 1-26. show interfaces t1 performance-statistics Command
Alternatively, you can specify the readout to only show a summary of the total
statistics over the last 24 hours by entering the Total-24-hour option.
The performance-statistics command is available only for physical
interfaces. To end the display, press
Ctrl+C.
To see realtime information on a physical or logical interface, enter:
Syntax: show interfaces <interface> <slot>/<port> realtime
or
Syntax: show interfaces <interface> <number> realtime
For example, to display realtime information about the T1 interface that is
installed in slot one, port one, enter:
ProCurve# show interface t1 1/1 realtime
This command displays a readout of the current statistics, which is updated
once every second. Figure 1-27 shows the realtime command screen for a T1
interface.
To pause the update, press
f. To resume the update, press r. To leave the
realtime screen, press
Ctrl+C.
Interval 74 Performance Statistics:
0 Errored Seconds, 0 Bursty Errored Seconds
0 Severely Errored Seconds, 0 Severely Errored Frame Seconds
0 Unavailable Seconds, 0 Path Code Violations
0 Line Code Violations, 0 Controlled Slip Seconds
0 Line Errored Seconds, 0 Degraded Minutes
Interval 75 Performance Statistics:
0 Errored Seconds, 0 Bursty Errored Seconds
0 Severely Errored Seconds, 0 Severely Errored Frame Seconds
0 Unavailable Seconds, 0 Path Code Violations
0 Line Code Violations, 0 Controlled Slip Seconds
0 Line Errored Seconds, 0 Degraded Minutes
Interval 76 Performance Statistics:
0 Errored Seconds, 0 Bursty Errored Seconds
0 Severely Errored Seconds, 0 Severely Errored Frame Seconds
0 Unavailable Seconds, 0 Path Code Violations
0 Line Code Violations, 0 Controlled Slip Seconds
0 Line Errored Seconds, 0 Degraded Minutes
To Next Page
Loading...
Need help?
General
