2-48
Controlling Management Access to the ProCurve Secure Router
Using SNMP to Manage the ProCurve Secure Router
Configuring SNMP Identity Information
You can enter the snmp-server commands in this section to configure the
information the ProCurve Secure Router will submit in response to queries
from authorized SNMP servers.
Change the Default Setting for the Router’s Chassis ID
The ProCurve Secure Router is identified by a default chassis ID. For most
environments, you should accept this default setting. However, if you need to
change the default setting, you can use the snmp-server chassis-id com-
mand. From the global configuration mode context, enter:
Syntax: snmp-server chassis-id <string>
Replace <string> with an alphanumeric string of up to 32 characters. For
example, you could enter:
ProCurve(config)# snmp-server chassis-id A432692
Use the no form of the command to return the chassis ID to its default setting,
“Chassis ID”:
Syntax: no snmp-server chassis-id
Specify the Router’s Location
You can specify the physical location of the ProCurve Secure Router with the
snmp-server location command. From the global configuration mode
context, enter:
Syntax: snmp-server location <string>
Replace <string> with an alphanumeric string of up to 256 characters in
length. For example, you might enter:
ProCurve(config)# snmp-server location Building1
If you want to include spaces in the string, you must enclose the string in
quotations marks as shown below.
ProCurve(config)# snmp-server location “Floor 8, Network Room”
Use the no form of the command to remove the location.
Syntax: no snmp-server location
To Next Page
Loading...
Need help?
General
