14-40
Using the Web Browser Interface for Basic Configuration Tasks
Configuring Ethernet Interfaces
Configuring Ethernet Interfaces
To configure an Ethernet interface from the Web browser interface, complete
the following steps. If you need more information about any of the options,
see Chapter 3: Configuring Ethernet Interfaces.
1. Click Physical Interfaces in the navigation bar.
2. Select the Ethernet port you want to configure (eth 0/1 or eth 0/2). The
Configuration for Ethernet window is displayed.
Figure 14-29. Configuration for Ethernet Window
3. If you want to document information about this Ethernet interface, enter
an alphanumeric string up to 80 characters in the Description box.
To Next Page
Loading...
Need help?
General
