14-39
Using the Web Browser Interface for Basic Configuration Tasks
Configuring Passwords to Control Management Access to the Router
Figure 14-28. Configure the Settings for a TACACS+ Server
b. For Address, enter the IP address of the TACACS+ server.
c. For Shared Key, enter the shared key. Re-enter the key to confirm it.
d. For TCP Port, accept the default port unless the TACACS+ server is
operating on a different port.
e. For Retries, configure the number of attempts that the ProCurve
Secure Router will make to contact the TACACS+ server.
f. Click Apply to save the settings for the TACACS+ server.
5. Select the tab for the type of access you want to configure:
• Enable Password
•Telnet
•Console
• SSH
• HTTP
• FTP
6. Select the Use Remote TACACS+ server option.
7. Click Apply to save your settings.
To Next Page
Loading...
Need help?
General
