1-61
Overview
Software Overview
Global Configuration Mode Commands
From enable mode, access the global configuration mode context by entering
configure terminal. It is from this mode context that you enter the
commands to configure the router; most of the commands in the global
configuration mode context are discussed in the various chapters included in
this guide. This section explains how to create an enable mode password,
activate the AutoSynch™ technology, and configure access to the Web
browser interface. For information on how to configure a particular router
interface or function, see the “Table of Contents” in either this Guide or the
Advanced Management and Configuration Guide.
hostname Command
It is often useful to give the router a name that helps to distinguish it from
other routers in your network. To change the router’s hostname, enter the
following command from the global configuration mode context:
ProCurve(config)# hostname <hostname>
autosynch Command
The AutoSynch™ feature is used with a compact flash card. Enabling
AutoSynch technology allows the router to automatically keep the startup-
config and Secure Router OS files in internal flash synchronized with the
startup-config and Secure Router OS files on the compact flash card.
The autosynch command is disabled in its default setting. To enable the
AutoSynch technology, move to the global configuration mode context and
enter:
ProCurve (config)# autosynch-mode
The CLI should display:
AutoSynch: SROS.BIZ synched
AutoSynch: startup-config synched
To disable the autosynch command, use the no command:
ProCurve(config)# no autosynch-mode
AutoSynch: SROS.BIZ not synched
AutoSynch: startup-config not synched
To Next Page
Loading...
Need help?
General
