1-42
Overview
Software Overview
Telnet
Open a Telnet session. (You enable and set the parameters for Telnet sessions
from the Telnet line configuration mode context.)
Syntax: telnet <A.B.C.D>
For information on how to set up a Telnet session, see Chapter 2: Controlling
Management Access to the ProCurve Secure Router.
Traceroute
Ping an IP address and display the hops that the packet takes en route to the
destination.
Syntax: traceroute <A.B.C.D>
The router will display a route to a destination up to 30 hops away. You can
end the traceroute process at any time by pressing
Ctrl+C.
show isdn-group [<interface number>] lists the ISDN group configurations and member
interfaces
show lldp [<cr> | device <name> | interface <interface ID> |
<neighbors>]
displays LLDP settings and information, including
information on specific neighbors
show memory heap [realtime] displays statistics for the router memory, including how
much has been used and how much is available
show modules gives information on the router’s modules, including the
type of module in each slot and the number of ports in each
module
show processes cpu shows the process statistics, including the load percent
for each process
show snmp displays the SNMP information and packets received
show sntp shows SNTP information
show thresholds displays the thresholds that have been exceeded on each
E1 or T1 interface
show version displays the router system software and hardware
versions
Option Result
To Next Page
Loading...
Need help?
General
