HP ProCurve 7000dl Series - Viewing Configuration Information; Viewing the Status of HDLC Interfaces

6-58
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Checking the Status of Logical Interfaces
Viewing the Status of HDLC Interfaces
To view information about the HDLC interface, enter the following command
from the enable mode context:
Syntax: show interface hdlc <number>
Figure 6-19 shows the results of this command for a sample network.
Figure 6-19. show interface hdlc <number>
Viewing Configuration Information
You can view the running-config for a logical interface by entering the follow-
ing command from the enable mode context:
Syntax: show running-config interface <interface> <number>
Replace <interface> with the logical interface and replace <number> with
the number you used to create that interface. For example, to view the
running-config for an HDLC interface, enter:
ProCurve# show running-config interface hdlc 1
Figure 6-20 shows the results of this command for a sample network.
Figure 6-20. show running-config interface hdlc <number>
hdlc 1 is UP
Configuration:
Keep-alive is set (10 sec.)
IP is configured
10.1.1.1 255.255.255.252
Link information:
Receive: bytes=6896, pkts=65, errors=0, broadcast=22
Transmit: bytes=8158, pkts=79, errors=0, broadcast=29
5 minute input rate 184 bits/sec, 0 packets/sec
5 minute output rate 216 bits/sec, 0 packets/sec
IP is UP Address=10.1.1.1 Mask=255.255.255.252
IP MTU=1500, Bandwidth=1984 Kbps
Status of interface
IP address
MTU and bandwidth
interface hdlc 1
ip address 10.1.1.1 255.255.255.252
no shutdown
bind 1 e1 1/1 1 hdlc 1