6-26
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Configuring the Logical Interface
To configure the signaling role, enter the following command from the Frame
Relay interface configuration mode context:
Syntax: frame-relay intf-type [dte | dce | nni]
Define the Frame Relay Signaling Type
You must configure the Frame Relay interface to use the same signaling type
that your Frame Relay service provider uses. From the Frame Relay interface
configuration mode context, enter:
Syntax: frame-relay lmi-type [ansi | auto | cisco | none | q933a]
Table 6-5 maps the Frame Relay signaling type to the setting that you must
enter for the frame-relay lmi-type command.
Table 6-5. Frame Relay Signaling
For example, to set the signaling type to auto, enter the following command
from the Frame Relay interface configuration mode context:
ProCurve(config-fr 1)# frame-relay lmi-type auto
The default setting is ansi.
Configure Frame-Relay Counters
The Frame Relay counters monitor status polls sent and received, track errors,
and change the endpoint’s signaling status from up to down, depending on the
number of errors counted within a set frame of events. Although you can tailor
the counter settings to your system, most applications do not require special
settings, so you should keep the default settings.
Signaling type Option Complete Command
Annex D ansi frame-relay lmi-type ansi
detect signaling type from incoming
message
auto frame-relay lmi-type auto
Cisco LMI cisco frame-relay lmi-type cisco
no signaling (disables signaling role
as well)
none frame-relay lmi-type none
Annex A q933a frame-relay lmi-type q933a
To Next Page
Loading...
Need help?
General
