8-67
Configuring Demand Routing for Primary ISDN Modules
Viewing Information about Demand Routing
Figure 8-21. Viewing the Status of a BRI Interface That Is in Use
Viewing Demand Sessions
You can view all of the dial-up connections currently established through
demand routing. From the enable mode context, enter:
ProCurve# show demand sessions
The sessions are listed in the order in which they were established. (See Figure
8-22.) For each session, this command lists:
■ demand interface through which the connection was established
■ IP address of the demand interface and the far-end router
■ interesting traffic that triggered the connection
■ number of links for each session if MLPPP is enabled
■ BRI interfaces through which the links were established
■ connection time
■ idle-timeout setting
bri 1/2 is UP
Line status: connected
Caller ID will be used to route incoming calls
Caller ID normal
Switch protocol: Net3 Euro ISDN
SPID 1 n/a, LDN 1 9631111
SPID 2 n/a, LDN 2 n/a
5 minute input rate 112 bits/sec, 0 packets/sec
5 minute output rate 112 bits/sec, 0 packets/sec
155 packets input, 8467 bytes, 0 no buffer
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame
0 abort, 0 discards, 0 overruns
157 packets output, 8408 bytes, 0 underruns
To Next Page
Loading...
Need help?
General
