8-61
Configuring Demand Routing for Primary ISDN Modules
Viewing Information about Demand Routing
Viewing Information about Demand
Routing
You can use show commands to view different aspects of your demand routing
configuration. For example, you can view the status of a demand interface and
any dial-up connections that are established through a demand interface.
Table 8-14 lists the show commands for demand routing.
Table 8-14. show Commands for Demand Routing
Viewing the Status of the Demand Interface
To view the status of the demand interface, enter the following command from
the enable mode context:
Syntax: show interfaces demand <number>
For example, to view the status of demand interface 1, enter:
ProCurve# show interfaces demand 1
Command Description
show interface demand <number> displays the status of the demand interface
show demand interface demand
<number>
displays a summary of information about the demand
interface, including the timers, state, physical
interface in use (if connection is up), last outgoing call,
and last incoming call
show interface <dial-up interface>
<slot>/<port>
displays status of physical interface
show demand sessions displays information about existing dial-up
connections established through demand routing
show deman
d resour
ce pool
<pool
name>
lists the resources assigned to the resource pool and
the demand interface associated with the resource
pool
show running-config displays the current configuration
show running-config interface
demand <number>
displays the current configuration for a demand
interface
To Next Page
Loading...
Need help?
General
