14-24
Using the Web Browser Interface for Basic Configuration Tasks
Enabling IP Services on the Router
Caution Disabling the HTTP Server will cause the Web browser interface to stop
functioning.
5. To change the HTTP Server Port, enter the desired port number in the box.
The default port is 80.
6. To enable the HTTPS Server, check the box.
7. To change the HTTPS Server Port, enter the desired port number in the
box. The default is 443.
8. To enable the router’s Secure Copy Server, check the box.
9. To enable the router as a Telnet server, check the box.
10. To change the Telnet Server Port, enter the desired port number in the
box. The default port is 23.
11. To enable the router as an SSH server, check the box.
12. To change the SSH Server Port, enter the desired port number in the box.
The default port is 22.
13. To make the changes effective, click Apply. If you want to return to the
previously configured settings, click Cancel to reset to the defaults.
Web Access Configuration
Web sessions with the ProCurve Secure Router have a default timeout of 10
minutes, after which you must log in again for continued access to the Web
browser interface.
To Next Page
Loading...
Need help?
General
