7-56
ADSL WAN Connections
Quick Start
5. Access the ADSL interface configuration mode context.
Syntax: interface adsl <slot>/1
For example, if the ADSL module is in slot two, enter:
ProCurve(config)# interface adsl 2/1
6. Activate the interface.
ProCurve(config-adsl 2/1)# no shutdown
7. Set the SNR margin.
Syntax: snr-margin <margin>
Replace <margin> with 1-15, which refers to decibels. For example, your
service provider may tell you to set the SNR margin to 6.
ProCurve(config-adsl 1)# snr-margin 6
8. Define the training mode. The default setting is Multi-Mode. For a list of
settings supported by the ADSL2+ Annex A module and the ADSL2+
Annex B module, see Table 7-9 on page 7-57.
Syntax: training-mode [ADSL2 | ADSL2+ | G.DMT | G.LITE | Multi-Mode |
READSL2 | T1.413]
ProCurve(config-adsl 2/1)# training-mode multi-mode
Note If you want to use a default setting, it is not necessary to enter the command.
9. Manually retrain the interface
ProCurve(config-adsl 2/1)# retrain
Retraining may take a minute. The ADSL interface will go down and then
back up.
10. View the status of the ADSL interface.
ProCurve(config-adsl 2/1)# do show interface adsl 2/1
Note The do command enables you to enter enable mode commands (such as show
commands) from any context (except the basic mode context).
To Next Page
Loading...
