10-31
Bridging—Transmitting Non-IP Traffic or Merging Two Networks
Quick Start
2. If so desired, change the router’s priority for becoming the root of the
spanning tree.
Syntax: spanning-tree priority <value>
The value can be from 0 to 63535.
3. If so desired, configure the cost of the connections on the router from the
logical interface for the connection.
Syntax: spanning-tree path-cost <value>
The cost can be from 1 to 63535. A higher cost lowers the chance that the
connection will be chosen. For example:
ProCurve(config-fr 1.1)# spanning-tree path-cost 60000
4. If a router interface connects to an edge device, configure the interface
as an edge port and enable the BPDU guard. Move to the logical interface
and enter:
ProCurve(config-eth 0/1)# spanning-tree edgeport enable
ProCurve(config-eth 0/1)# spanning-tree bpduguard enable
For Frame Relay and ATM subinterfaces enter:
ProCurve(config-fr 1.1)# spanning-tree edgeport
ProCurve(config-fr 1.1)# spanning-tree bpduguard enable
To Next Page
Loading...
Need help?
General
