14-75
Using the Web Browser Interface for Basic Configuration Tasks
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Figure 14-53. HDLC Configuration Window
1. Enter a description in the Description box if you want to record some
information about the HDLC interface. This information will be displayed
in the interface’s running-config.
2. Click the Enabled box to activate the interface.
3. If you do not want the interface to use Weighted Fair Queuing, check the
box to deselect it. For more information about WFQ, see “Configuring
Quality of Service” on page 16-58 of Chapter 16: Using the Web Browser
Interface for Advanced Configuration Tasks in the Advanced Manage-
ment and Configuration Guide.
4. For most environments, you will accept the default MTU of 1500. If you
need to adjust the MTU, however, enter the new value in the MTU box.
5. Verify that the HDLC is bound to the proper physical interface by checking
the Physical Interface field.
To Next Page
Loading...
Need help?
General
