14-91
Using the Web Browser Interface for Basic Configuration Tasks
Configuring Demand Routing for a Primary or Backup Connection
Figure 14-65. Configuration for a BRI Interface
3. Enter a description in the Description box if you want to document
information about the BRI interface. This information will be displayed in
the running-config under the appropriate interface heading.
4. To activate the interface, select the Enable box.
5. If you want the BRI interface to replace the caller ID of incoming calls
with a different number, select the Caller Id Override box. Enter the
number that replaces incoming numbers in the Override Number field.
6. Select the ISDN signaling used by your service provider from the Switch-
Type pull-down menu.
7. Enter the local directory number (LDN) for the ISDN line in the LDN1
field.
8. If your service provider has assigned this line a secondary LDN, enter it
in the LDN2 field.
9. In North America, service providers assign ISDN lines Service Profile
Identifiers (SPIDs). Enter your line’s primary SPID in the SPID1 field. If
the line has been assigned a secondary SPID, enter it in the SPID2 field.
10. Click Apply.
To Next Page
Loading...
Need help?
General
