Keba Kemro K2 - Description of the Elements

Fig.4-47: Mask "Nozzle options"
4.43.3 Description of the elements
Auto purge settings
Field Description
Injection
Setting of Pressure and Velocity up to specified Position (To) for
injection during auto purge.
Decompression
Setting of Pressure and Velocity up to specified Position (To) for
descompression during auto purge.
Plasticize
Setting of Pressure and rpm up to specified Time for plasticizing
during auto purge.
Purge time Displays the elapsed time for purge.
Purge count Specification of the cycles for purging at change of material.
Shut off nozzle
Field Description
Close
Specifying Pressure, Velocity and Active Time for closing the
shut-off nozzle.
Shut-off nozzle will be closed with the specified parameters after
injection has finished resp. after each process where material is
carried out of the nozzle.
Open
Specifying Pressure, Velocity and Active Time for opening the
shut-off nozzle.
Shut-off nozzle will be opened with the specified parameters be-
fore injection starts resp. before each process where material is
carried out of the nozzle.
Description of the operating masks KePlast.HMI.KVB
© KEBA 2016
User's manual V3.05116