Keba Kemro K2 User Manual

3.1.1 Status bar
A status bar is displayed at the top and bottom section of the basic layout. The
representation of the status bar depends on the resolution of the operating
panel that is used.
Fig.3-2: Top status bar for resolution 800x600
1
... Alarm information. If an alarm
or warning appears an alarm
line is fade in. The alarm line
disappears by pressing the
alarm button on the operation
panel. After that an icon sig-
nalizes that an alarm or warn-
ing is currently acitve. The
number next to the icon
shows the number of warn-
ings/alarms that are currently
active. A grey icon signalizes
a warning. A red icon signal-
izes an alarm. The number
that is part of the icon shows
the alarm class.
2
... Display of the actual system pressure, actual
system velocity (% of the maximum pump ve-
locity), actual inject pressure, acutal ejector po-
sition, acutal mold position. acutal screw position
and acutal screw revolution.
3
... Current user / user level that
is logged in.
4 ... The currently active movements are displayed.
There are two different modes how to display the
active movements. Either just an icon or an icon
+ short text. The setting can be done in mask
"Display settings"
5
... Current time
Operation and display KePlast.HMI.KVB
© KEBA 2016
User's manual V3.0522

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English