Keba Kemro K2 - Description of the Elements

4.15.3 Description of the elements
Venting
Field Description
Stages
Number of adjustable stages for venting move-
ment (maximum of 5).
Venting 1..n
Setting of
● Velocity: Veclocity for the venting stage.
● Time: Time that a stage is active
● Position: Mold position for the stage. The
possible mold positions depend on the con-
figured velocity and time for the stage.
● Force: Set force for clamp force control
for each stage are configured.
Mold position
Defines mold position where mold close move-
ment stops and venting sequence begins.
Sequence Mode
● Parallel: Venting movement is exectued
parallel to inject movement.
● Sequential: Venting movement is ex-
ectued sequential to inject movement.
Activate Mode
● No use: Venting deactivated.
● After inject: Venting starts after inject
● Inject position: Venting starts at a defined
inject position
● Inject pressure: Venting starts when a de-
fined inject pressure is achieved.
Inject Pressure
Venting starts if configured inject pressure is
achieved.
Inject Position
Venting starts if configured inject position is
achieved.
Delay time Delay time for starting venting.
Coining
Field Description
Stages
Number of adjustable stages for coining move-
ment (maximum of 5).
Coining 1..n
Setting of
● Velocity: Veclocity for the coining stage.
● Time: Time that a stage is active
● Position: Mold position for the stage. The
possible mold positions depend on the con-
figured velocity and time for the stage.
● Force: Set force for clamp force control
for each stage are configured.
Mold position
Defines mold position where mold close move-
ment stops and coining sequence begins.
KePlast.HMI.KVB Description of the operating masks
© KEBA 2016
User's manual V3.05 67