Keba Kemro K2 - Description of the Elements; 4.110 Calibration Pump; Purpose; Description of the Mask

4.109.3 Description of the elements
Name Description
Points Number of points in the linearization table.
Actual Voltage Displays the actual voltage of the sensor.
Start Index
Since only a maximum of 9 linearization points
can be displayed on the mask, this field serves
for navigation purposes. The input value al-
ways corresponds to the index of the element
displayed first. Example: Value 1: linearization
points 1 to 9 are displayed. Value 17: lineari-
zation points 17 to 25 are displayed, etc.
Modify index
Linearization points can be deleted or added.
The configured index defines which lineariza-
tion point gets deleted resp. after which linea-
rization point a new point gets added.
V / bar
Calibration of the mold pressure sensors is
done by entering the pressure [bar] and the
voltage [V] for each linearization point.
4.110 Calibration pump
4.110.1 Purpose
This mask can be used to manually calibrate the pump pressure and pump
velocity for the selected pump (Tab1 - Tab3). Additionally the minimum and
maximum output voltages for pressure and velocity during the calibration can
be set.
4.110.2 Description of the mask
The manual calibration of a sensor is done by entering values in a linearization
table.
Description of the operating masks KePlast.HMI.KVB
© KEBA 2016
User's manual V3.05214