4.71 IO Monitor PWM outputs (PO)
4.71.1 Purpose
This mask shows the values of the pulse width modulation (PWM) outputs (PO)
of the controller/periphery.
4.71.2 Description of the mask
The values of all PWM outputs are displayed. Further it is possible to force an
output to a certain percentage.
If an IO is physically available but no variable is allocated to the IO, only the
IO- number is displayed. However it is possible to force the IO.
If an IO is physically available and allocated to a variable but no text is assigned
to the variable, the name of the system variable is displayed.
Fig.4-75: Mask 'IO Monitor PWM outputs (PO)''
KePlast.HMI.KVB Description of the operating masks
© KEBA 2016
User's manual V3.05 157
To Next Page
Loading...
