2.2 General safety instructions
WARNING!
The system (hardware and software) only meets category B according to
EN ISO 13849-1. Thus it is not intended for usage in safety-relevant control ap-
plications in the field of personal safety (e.g. emergency stop).
To implement potentially necessary safety-relevants control tasks, always use
additional external safety devices according to EN ISO 13849-1 that are intended
for the particular purpose and meet the necessary functional safety.
For further information see EN ISO 13849-1 and refer to chapter "EC directives
and standards" in the manuals for a list of norms applying to the product.
The safety notices for the installation and commissioning of the product can be
found in the user manuals of the components or in the system manual and must
be read and observed before installation or commissioning.
The user manual must be kept throughout the entire service life of the product.
WARNING!
● This document serves as template for the machine manufacturer.
● Prior to transfer to the machine operator the contents of this document must
be adjusted to the injection molding machine on which the system is used.
● The machine manufacturer must insert safety instructions at the relevant
positions in the document.
Safety Notes KePlast.HMI.KVB
© KEBA 2016
User's manual V3.0520
To Next Page
Loading...
Need help?
General
