Keba Kemro K2 User Manual

4.95.3 Description of the elements
Operation and movement settings
Field Description
Nozzle movement mode
Following movement modes for the nozzle are available.
● Position: Nozzle position is determined by limit switches or
transducer.
● Time: The nozzle movement is time-controlled (no limit switch
or position sensor).
Two button mode
Following modes are possible:
● Press to start: Both start buttons must be pressed to start the
autocycle. After starting the cycle, the buttons can be released.
● Press till high pres.: Both start buttons must be pressed to
start the autocycle and must remain pressed until the begin-
ning of high pressure phase.
This option is only for vertical IMM´s with two start buttons avail-
able.
Mold adjust
Field Description
Mold height motor
Specification of the type of drive for the mold height adjustment
with the following selection options:
● hydraulic: Hydraulic drive.
● electric: Electric drive.
Limit switch mode
Type of limit switch for the mold height adjustment.
● Norm. Closed: If the end position has been reached, the con-
tact is closed.
● Norm. Open: If the end position has been reached, the contact
is opened.
Safety gates
WARNING!
The system (hardware and software) only meets category B according to
EN ISO 13849-1. Thus it is not intended for usage in safety-relevant control ap-
plications in the field of personal safety (e.g. emergency stop).
To implement potentially necessary safety-relevants control tasks, always use
additional external safety devices according to EN ISO 13849-1 that are intended
for the particular purpose and meet the necessary functional safety.
For further information see EN ISO 13849-1 and refer to chapter "EC directives
and standards" in the manuals for a list of norms applying to the product.
The safety notices for the installation and commissioning of the product can be
found in the user manuals of the components or in the system manual and must
be read and observed before installation or commissioning.
The user manual must be kept throughout the entire service life of the product.
Description of the operating masks KePlast.HMI.KVB
© KEBA 2016
User's manual V3.05192

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English