Keba Kemro K2 - Heating Nozzle Setup - Tab2; Purpose; Description of the Mask; Description of the Elements

Field Description
Pre heating velocity Specification of the velocity for oil pre heating.
Pre heating pressure Specification of the pressure for oil pre heating.
4.46 Heating Nozzle Setup - Tab2
4.46.1 Purpose
This mask is used to specify the sensor types for the nozzle heater and the
hopper (material entrance).
4.46.2 Description of the mask
Fig.4-50: Mask "Heating nozzle setup - tab2"
4.46.3 Description of the elements
Zone settings
For each heating zone the following settings can be made:
KePlast.HMI.KVB
Description of the operating masks
© KEBA 2016
User's manual V3.05 121