Keba Kemro K2 User Manual

Closed loop
Field Description
Servo press release
(optional)
Calibration in order to get characteristic of servo valve when re-
leasing pressure.
Only displayed if a servo valve is available.
Injection
Injection speed calibration:
Detection of the injection control parameters.
Display of the maximum possible inject speed.
Hold controller
Hold calibration:
Detection of the hold control parameters.
4.104 Calibration - Tab auto calibration settings
4.104.1 Purpose
This mask can be used for setting basic configurations for the auto calibration.
4.104.2 Description of the mask
This mask allows the selection of the axis that is used to calibrate each pump.
The delay time between pressure calibration steps can be set. Furthermore
this delay time is effective for the pressure calibration of pump and servo valve.
Besides these, the maximum voltage output for the velocity during pressure
calibration and the maximum position relative to the screw , mold and ejector
stroke during velocity calibration can be set.
Fig.4-110: Mask "Auto calibration settings"
KePlast.HMI.KVB
Description of the operating masks
© KEBA 2016
User's manual V3.05 207

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English