Keba Kemro K2 User Manual

Fig.4-7: Mask "Mold setup tab 1"
4.5.3 Description of the elements
General settings
Field Description
Use adaptive mold open
By selecting this option the mold open movement will be opti-
mized. Thus a jerky stop of the mold when reaching mold open
endposition because of different hydraulic characteristics of ma-
chines can be avoided.
To use this option, a minimal profile output and a valve delay time
for "mold open" movement have to be set in mask "Mold setup
advanced tab 1".
Open after protect
By selecting this option the mold opens automatically when a mold
protect event occurs. Otherwise the machine stops when a mold
protect event occurs.
Mold protect retry count
The duration of Mold HighPressure (last profile stage in mold pro-
file) is shown in the left field Actual. The monitoring time is entered
in the middle field Limit. The difference between the two values is
shown in the right field Differ.
Mold open during plast
Activation of the mold open movement during plasticize.
This field is only displayed if a shutoff nozzle is configured.
Amplifier activation force
Activation clamp force for opening the pressure amplifier valve
during clamp pressure build up.
This field is only shown for direct clamping machines and if a clamp
force sensor and a pressure amplifier valve is available.
Force build up time
Setting of the force build up time for movement mold close.
This field is only shown at a direct clamp machine with no clamp
force sensor.
Description of the operating masks KePlast.HMI.KVB
© KEBA 2016
User's manual V3.0548

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English