4.107
Calibration pressure sensors
4.107.1 Purpose
This mask can be used to manually calibrate the pressure sensors.
4.107.2 Description of the mask
The manual calibration of a sensor is done by entering values in a linearization
table.
Fig.4-113: Mask ''Calibration pressure sensors"
4.107.3 Description of the elements
Name Description
Points Number of points in the linearization table.
Actual Voltage Displays the actual voltage of the sensor.
Start Index
Since only a maximum of 9 linearization points
can be displayed on the mask, this field serves
for navigation purposes. The input value al-
ways corresponds to the index of the element
displayed first. Example: Value 1: linearization
points 1 to 9 are displayed. Value 17: lineari-
zation points 17 to 25 are displayed, etc.
KePlast.HMI.KVB Description of the operating masks
© KEBA 2016
User's manual V3.05 211