Keba Kemro K2 User Manual

Fig.4-12: Maske "Mold height adjust"
4.10.3 Description of the elements
General settings
Field Description
Adjust mode
Mode of mold height adjustment with the following selection op-
tions:
Force:
The mold height is determined by the set clamp force in input field
'Clamp force' (specification of maximum clamping force and max.
system pressure in the mask 'Machine limits' is required).
Position:
The mold height is set depending on the position. This requires
specification of the minimum and maximum mold height and the
origin of the mold height in the mask 'Machine limits'.
Pressure:
The mold height is determined by the set clamp pressure in input
field 'Clamp pressure'. In this case the set profiles for mold close
and mold open movement will be executed.
Adjust by one gear
When this function is activated the manual mold height adjustment
is executed in setup mode via single steps. The mold always
moves up to the next detected impulse.
Adjust by time
When this function is activated the mold height adjustment is exe-
cuted over the configured period.
Auto mold adjust Starts the automatic mold height adjustment.
Description of the operating masks KePlast.HMI.KVB
© KEBA 2016
User's manual V3.0558

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English